Hints and Things does not use any 1st Party cookies - more information .
Recommended Hot Tub Care Maintenance Routine
Check sanitiser level & dose as required
Clean filter cartridge using Cartridge Cleaner or SpaGuard FilterBrite.
Due to the build up of Total Dissolved Solids (TDS) the hot tub will need completely draining & refilling. There are no hard and fast rules as to when this should be done but the following formulation seems to work well in practise:
Hot tub litres divided by daily bathers divided by 12 = days between draining & refilling
Example : 1200 litres divided by 2 divided by 12 = 50 days.
By balancing the water you are creating the right conditions for bather comfort, chemical efficiency & equipment protection. A number of factors are involved in balancing the water but the main areas are :
This will vary depending on where you live and where your water supply comes from and it is very important that the correct level is established. As a guide, soft water tends to be low in Calcium Hardness and hard water more obviously is high.
The level should be checked each time you top-up or refill the hot tub with fresh water. The ideal Calcium Hardness level for hot tubs is between 100 - 200mg/l.
When it is below this level the water could be corrosive which could lead to damage of plant equipment such as the heater. If this is the case apply Hardness Increaser to achieve the correct level.
When it is above this level the water has a tendency to appear cloudy and also calcium can precipitate out and deposit itself on the tub shell finish, heater element, cartridge element & within pipe work. If this is the case apply No Scale to achieve the correct level.
TA acts as a buffer to prevent pH change and if the level is too low the pH will fluctuate widely, if too high pH adjustment will be difficult to effect. The ideal Total Alkalinity for hot tubs is between 125 - 150mg/l.
When it is below this level not only will pH fluctuate but the water could be corrosive, cause damage to equipment and be uncomfortable to bathers. Use Total Alkalinity Increaser to raise levels.
When it is above this level not only is pH difficult to adjust but also the water could be scale forming and clarity impaired. Use pH Minus to reduce levels.
Regular pH checks are an essential part of your tub maintenance routine using Test Strips.
The pH scale has a range of 0 - 14 with 0 being very acidic, 7 being neutral & 14 being very alkali.
For tubs the ideal range is between 7.4 - 7.6, this being slightly alkaline to protect the hot tub and prevent equipment corrosion. This also provides the most comfortable conditions for bathers and good sanitiser efficiency.
If the level is below 7.4 use Soda Ash to raise the level.
If the level is above 7.6 use Dry Acid to reduce the level.
The sanitising of your hot tub water is necessary to kill bacteria and help in the prevention of algae growth. The level should be checked regularly using Test Strips and can be in the form of Chlorine or Bromine
This is an effective hot water sanitiser and ideally suited to hot tubs. It is effective over a wide pH range and has little odour. Comes in tablet form making it easy to apply and avoids having to dose everyday.
The ideal Bromine level is between 3 - 6mg/l.
This is available in granule form which are rapid dissolving and therefore a good sanitiser. It has little effect on the pH levels.
The ideal Chlorine level is between 3 - 5mg/l.
It is necessary to oxidise your hot tub weekly using Non Chlorine Shock.
Hot Tub Speciality Products.
Other products also help keep your hot tub clean, clear and enhance your bathing pleasure.
Control of Foam
If excessive foaming is a continuous problem drain the tub and refill with fresh water.
Ensuring Water Clarity
Discolouration or cloudiness of the water is often caused by minute particles suspended in the hot tub water which are too small for the filtration system to remove.
Soaps, cosmetics, body oils and greases can all cause dull, cloudy water. Encourage hot tub users to shower before getting into the hot tub to minimise these problems.
Clarifier used once a week will assist in the removal of suspended matter via the filtration system thus restoring and maintaining the water clarity.
Make sure that you follow the routine and your spa/hot tub will be as new all the time.
A few simple routines will keep your water sparkling clean and your hot tub in excellent condition - Hot Tub Chemicals Maintenance
Copyright © 2000-2017 Hints and Things
Hints and Things cannot be held responsible for any information given on this site nor do they necessarily agree with, or endorse, the views given by third parties.